Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Trusted Air Duct Repair for Everett Homeowners
A leak you can’t see is still a leak you pay for, and that’s the frustration behind most air duct repair calls in Everett. Air pushing through a torn joint or a separated boot never reaches the room it was meant for, so the furnace runs longer and the upstairs stays cold. We fix the ductwork itself, not just the dust inside it. Duct Cleaning Everett has been at this, and we carry Rotobrush camera inspection equipment so every breach is found and every repair is verified on screen before we close up. Call (833) 991-7936 and we’ll book a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Same-day repair is often possible when you call early.
HVAC Duct Installation
HVAC Duct Installation is the work of running a new duct system, or a new branch of one, for an addition, a conversion, or a home whose old layout never worked. In Everett’s older housing stock, that often means tying a new run into a trunk that was sized decades ago for a smaller furnace, and the duct has to match the blower, not the other way around. We design runs in contractor-grade materials, seal every joint, and pressure-check the result before the ceiling goes back. We’ll walk you through the layout and the price is set per job by the written estimate, so nothing is agreed until you’ve seen the numbers. Cost on a simple added branch usually runs a few hundred dollars; a converted room or small addition runs somewhat more, and a full system with new trunks and branch runs sits at the higher end. The written estimate sets the final price.
Load and Sizing Review
We size new duct to the equipment that’s actually there, not to a generic rule of thumb. If the return is undersized, adding supply runs alone won’t fix a room that runs hot, and we’ll tell you that before you spend money. The camera also shows whether the existing trunk can take the new load.
Sealed Joints and Verified Flow
Every connection we make gets mechanically fastened and sealed, then checked for leakage at the register. You’ll see the airflow readings at the end, not just a promise that it’s better. If a register still whistles, we adjust the damper before we leave.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Air Duct Replacement
Air Duct Replacement is for duct that’s past repair: crushed flex in a crawlspace, rusted-out trunk sections, or a system that has been patched so many times it no longer holds pressure. Around Everett, the common triggers are a remodel that rerouted the layout and duct runs that were never properly supported, so they’ve sagged and pinched over time. We remove the failed lengths, rebuild them in the same footprint where possible, and seal the whole run before it’s covered. Pricing depends on how much of the system is involved and how accessible it is; an estimate is free and the price is fixed per job in writing. Clear access and a single problem zone keep the figure down, while multiple levels or buried duct push it up.
Partial or Full Replacement
You don’t need to replace duct that’s still sound. We scope the work to the failed sections and leave the rest alone, which usually means a smaller job and less disruption. Where a trunk is failing in several places, we’ll say so plainly and price both paths.
Access Before We Start
We check crawlspace, attic, and closet access first, because that single factor decides how the job goes. If something has to be opened to reach a run, we flag it in the estimate rather than discovering it later. No surprises after the truck is parked.
Ductwork Repair
Ductwork Repair covers the breaches, tears, and failed connections that cleaning alone can’t fix. Foil-faced flex that has torn at the collar, a joint that’s separated behind a ceiling register, a boot pulled away from the subfloor, or a trunk section crushed underfoot are the usual findings. We scope it with the Rotobrush camera so the problem is seen, not guessed, then seal, re-tape with proper foil and mastic, or re-support the run. Nikro HEPA vacuum containment goes in first so the dust we disturb stays captured rather than spreading through the house. Most repairs land in the low hundreds of dollars and depend on how many leaks there are and how easy they are to reach. The estimate is free, and the price holds once it’s written.
What We Look For First
Leaks at the plenum, at elbow transitions, and at the run-outs to registers cause most of the airflow loss we find. We inspect those points with the camera before quoting anything. Once we know where the air is going, the repair plan is short.
Repairs That Hold
Tape and hope isn’t a fix. We fasten and seal joints so they stay sealed when the system cycles, and we support sagging runs so they don’t pinch again. If duct has to be replaced rather than patched, we’ll say so up front.
Duct Replacement
Duct Replacement is the swap of a failed section or a whole run for new duct of a better spec, usually flex that’s collapsed or old rigid duct that no longer fits the equipment. In Everett, the common call is a return that has been squeezed into a closet and can’t move enough air, or supply duct that’s been flattened in a crawlspace over decades of remodels. We match the replacement to the blower and to the room’s actual heat load, then pressure-check the run. Cost runs from a modest single-run swap to several times that for a full system rebuild, depending on length, materials, and how hard it is to reach. The written estimate sets the final price.
Matching Duct to the Equipment
New duct has to move the volume the furnace or heat pump was built for, or the system will short-cycle no matter how clean it is. We confirm the equipment spec before choosing duct size. Then we check the airflow at the far registers to prove the match.
Reworking the Layout
Sometimes the best replacement is a shorter, straighter run. We look at whether moving a trunk a few feet gets the air there with less duct and fewer turns. Fewer turns is quieter and easier to keep clean.
Ductwork Installation
Ductwork Installation is the first-time build of a duct system: new construction, a garage or basement conversion, or a workshop that needs heat. It’s also the job when a house has a furnace but no proper duct at all, which happens more than you’d think in this part of Snohomish County. We lay out the runs around the rooms that need air, size the trunk and branch to the equipment, and build it with proper supports and sealed joints so the system works from the first heating season. We use Rotobrush and Nikro equipment to verify the finished system, and we can add filtration components from Aprilaire or Guardsman at the same time if you want a better filter setup from day one. The estimate is free and the price is per system, agreed before we start.
Planning Around the House
Old houses have closets, chases, and ceiling cavities you can use, and forced runs that wind up ugly. We plan the route before anyone cuts. The layout also has to leave room for a filter and service access, which plenty of builders skip.
Testing at the Registers
When the system is done, we check airflow room by room rather than just listening at the furnace. A register that’s weak gets adjusted before we call it finished. You’ll see the before-and-after readings yourself.
Brands We Service
We work with Aprilaire and Guardsman filtration and system components, and we know where each of them wears out. Aprilaire media cabinets collect a lot of dust at the frame, and a seal that’s gone lets unfiltered air past the filter, so we check fit and seal as part of the job. Guardsman filters are straightforward and we can match the cabinet to the equipment you have. We also carry Abatement Technologies equipment for situations where the contamination load in the air system needs more than routine dust removal.
On the inspection side, Rotobrush handles the camera and brushing, and Nikro HEPA vacuums handle containment, so the work is verified on screen and the debris is captured, not recirculated. Whether you have a Honeywell, Aprilaire, or Guardsman setup, or any other make, we can help.
See the difference
Before
After
Before
After
Before
AfterSigns You Need a Pro Right Now
- Rooms that won’t heat evenly. If one room stays cold while the rest is fine, the duct serving it has likely separated or pinched somewhere along the run. That’s a quick camera check, and it’s worth catching before the bill climbs.
- Whistling or roaring at a register. A register that hisses is pushing against a restriction, usually a crushed or undersized run. It doesn’t fix itself, and the fan keeps working harder in the meantime.
- Dust that returns right after cleaning. If dust settles again within days of a cleaning, the system is drawing it in through a breach. Repair comes before cleaning in that case.
- Duct hanging loose in the crawlspace. Sagging flex has lost its support and is pinching closed at the low point. It needs re-supporting and probably a replacement of the sagging length.
- Higher heating bills with no other change. Leaky duct sends heated air into the attic or crawlspace instead of the room. It’s one of the easier things to check and one of the cheaper to fix.
Our Process, Step by Step
- 1
You call and describe the symptom. We ask what the rooms are doing so we can bring the right equipment. Call (833) 991-7936. We answer 24/7.
- 2
We inspect with the camera. Rotobrush camera inspection runs the full system, including the plenum, trunk, and branches. You see what we see on screen.
- 3
We scope and quote in writing. The estimate lists the breaches, the proposed repair, and one flat price for the job. Nothing starts until you agree.
- 4
We contain, then repair. Nikro HEPA negative-pressure equipment goes in before any breach is opened. We fasten, seal, and re-support the duct so it holds.
- 5
We verify and show you the result. A second camera pass confirms the repair, and we photograph the inside of the duct so you have the record. If you want filtration upgrades, we can quote Aprilaire or Guardsman components then.
How Much Does Air Duct Repair Cost in Everett?
A typical air duct repair in Everett runs a few hundred dollars for a single failed joint or torn run, and climbs toward the low thousands when the work involves a rebuilt trunk or replacement of most of a system. The range comes down to three things: how many leaks there are, how accessible the duct is, and whether the fix is a patch or a real rebuild. A single separated connection behind a register is the low end. A crawlspace trunk that has to be re-supported and re-sealed in several places is the middle. A full replacement of failed runs, especially across multiple levels, is the high end.
What pushes the price up is access, not parts. Duct buried under insulation or behind finished drywall takes longer to reach and to put back. Long, complicated runs with many elbows take longer to seal properly. If your duct has been patched repeatedly, expect us to price a replacement section rather than another patch, because the patch won’t hold.
The way to avoid overpaying is to get the scope in writing before anything is touched. A quote that says “duct cleaning and repairs” without naming what gets fixed is the one to question. Ask for the inspection findings, ask for the flat price per job, and ask for photos of the inside of your duct afterward. We put all of that in writing, and the estimate itself is free.
Our Service Area Near Everett
We serve Everett and the surrounding Snohomish County communities, including Bunk Foss, Lake Cassidy, Three Lakes, Lochsloy, Sisco Heights, and Canyon Creek, and out toward Warm Beach on the northwest side. If you’re searching for duct cleaning Everett or need repair work anywhere in that ring, we can schedule you into the next opening. Travel time from our base in Everett to these towns is generally short, and the estimate is free wherever you are.
Serving Everett, WA – Our Local Coverage Area
We serve Everett and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Air Duct Repair in Everett
Air duct repair is the fixing of physical damage to the duct system itself: torn flex, separated joints, crushed sections, failed connections, and sagging runs. It’s different from cleaning, which removes the dust inside a system that’s otherwise sound. Many homes need both, and we’ll tell you which comes first.
Most repair visits take a few hours, and a single joint or torn run can be done within one appointment. Jobs that involve a rebuilt trunk or replacement of long runs take longer and may need a second visit. We give you the expected timeline with the written estimate, so you know what the day looks like.
Most repairs land in the low hundreds of dollars for a single breach, with larger rebuilds approaching the low thousands. The price depends on how many leaks there are and how accessible the duct is. Call (833) 991-7936 for an exact quote. The estimate is free and the price is fixed per job in writing.
Yes, we work with Aprilaire and Guardsman filtration components and can check fit, seal, and filter condition as part of a repair visit. We also carry Rotobrush camera and Nikro HEPA equipment for the inspection and containment side. Whether you have one of those or any other make, we can help.
Same-day repair is often possible when you call early in the day, and we book you into the next opening if the schedule is full. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday; we’re closed on Saturday. A call outside dispatch hours is booked into the next opening.
Yes, our repair work carries a workmanship guarantee, and we stand behind the seals and connections we make. If something that was repaired fails, we come back and fix it. Ask for the guarantee details in writing with your estimate so you know what’s covered.
Clear access to the furnace, the crawlspace hatch, and any attic opening, and move breakables away from the registers. If a contractor has worked on the duct recently, let us know so we check those spots first. That’s all we need, and the rest we handle on site.
Schedule Your Air Duct Repair Service in Everett Today
If your rooms won’t heat evenly or dust keeps coming back, a camera check will tell you why in under an hour. Call (833) 991-7936 for a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’ll show you the breach on screen, quote one flat price per job in writing, and photograph the finished work so you can see it held.
Written by the team at Duct Cleaning Everett.